General
Attention
The tool diameter may not be greater than the distance between the laser transmitter and receiver.
Attention
During the cycle, all active offsets must be suppressed using #SUPPRESS OFFSETS except for tool offsets to ensure uniform positioning during calibration and measuring.
The 3 files must be present and configured before use, otherwise the cycles cannot run.
- SysCalibConfigLaser.nc
- SysCalibConfigLaserOn.nc
- SysCalibConfigLaserOff.nc
Depending on the parameters, a machine stop is executed in the event of a tool breakage or a warning with the error message P-ERR-13461 is output.
If wear exceeds the specified tolerance, the machine is stopped depending on the parameters or a warning with the error message P-ERR-13450 is output.