ID 150104

Element adr_hr_zaehler in HAND_MDS greater than HLI array for hand increments.

Description

The manual mode parameters are read and interpreted by the CNC.

There CNC detects that value of manual operation parameters P-MANU-00004 exceeds CNC system internal limit.

Parameter P-MANU-00004 indicates the address at which the handwheel counters are sent to the CNC. In the case of the message, the high-level interface to the PLC was defined as the transfer location (see P-MANU-00003). Which area of interface is selected to give counter reading of handwheel is fixed by parameter P-MANU-00004 .

Response

Class

3

Manual mode parameters are not transferred to the CNC.

Solution

Class

6

Correction of the value for P-MANU-00004,
P-MANU-00004 <= the limit value (see parameter 2 of the message).

Reinterpret manual mode parameters by restarting CNC System.

Parameter

%1:

Current value [-]

Index of interface to give counter reading of handwheel to CNC which is set within manual mode parameter data set.

%2:

Limit value [-]

Maximal allowed index value.

%3:

Logical control element number [-]

Number of logical input device which parameters lead to that message.

Error type

2, Error message by data transfer from parameter list into control device.