Parameterisation
For more information on cycle behaviour depending on the parameterised reference cycle, see section Process.
Required input parameters
Input parameters | Description |
@P4 | Return distance (relative to current Z position) |
@P100 | Reference cycle as character string "SysDrillTapping" or 0: Thread tapping "SysDrillThreadMilling" or 1: Drill thread milling "SysDrill" or 2: General drilling cycle |
@P132 | Feed rate for retraction in Z (values in mm/min, inch/mm) (not required for thread tapping) |
Optional input parameters
Input parameters | Description |
@P7 | Pitch (required for thread tapping) |
@P18 | Thread type -1: left-hand thread 1: right-hand thread (default) |
@P24 | Spindle speed (required for thread tapping) |
@P40 | Position of centre in X (required for drill thread milling) |
@P41 | Position of centre in Y (required for drill thread milling) |
It is recommended to use the Syntax check to verify whether the input parameters are correctly assigned.