Programming #CYL ORI PROFILE [..]

Notice

notice

The kinematic parameters in ID 93 must be set for this machining type.

Syntax for selecting and parameterising, active as of the next motion block:

#CYL ORI PROFILE [ EDGES<expr>  ROUNDING<expr>  LENGTH1<expr>  [ LENGTH2<expr> ]
                                     [ VEL<expr> ]   [ ACC<expr> ] ]                                (modal)

EDGES<expr>

Number of edges (corners) of the profiled tube, positive integer

The minimum number of corners on the profile is limited to 3 and the maximum number to 16.

ROUNDING<expr>

Edge rounding radius (corner radius), [mm, inch].

LENGTH1<expr>

Side length for symmetrical tubes or first side length for rectangular tubes, [mm, inch]

LENGTH2<expr>

Second side length for rectangular tubes, [mm, inch]

VEL<expr>

Path velocity on edge rounding [mm/min]

ACC<expr>

Path acceleration on edge rounding [mm/min²]

Syntax for deselection:

#CYL OFF                                                                                         (modal)

Programing Example

prg_example

#CYL ORI PROFILE [..]

(Symmetrical square profile with 100 mm edge length)

(and 10 mm edge rounding radius)

N10 #CYL ORI PROFILE [EDGES=4 ROUNDING=10 LENGTH1=100]

...

(Rectangular tube with edge lengths of 100 mm)

(and 80 mm and 15 mm edge rounding radius)

N10 #CYL ORI PROFILE [EDGES=4 ROUNDING=15 LENGTH1=100 LENGTH2=80]

...

(Reduced path dynamics on the profile rounding)

N10 #CYL ORI PROFILE [EDGES=4 ... LENGTH2=50 ACC=1000000]