PSC programming with OP1 and OP2

#HSC [ON | OFF] [ [OPMODE <expr>] [CONTERROR <expr>] ]                                             (modal)

ON

Enable HSC programming

OFF

Disable HSC programming

OPMODE <expr>

Set operation mode:

Valid values

Meaning

1

Insert transition polynomials

2

Generate interpolating spline curves

CONTERROR <expr>

Define maximum contour error in [mm, inch]:

Valid values

Meaning

>= 0.0

Maximum contour error "ε"

Is only valid in combination with active OPMODE 1.

If the parameter is set in OPMODE 2, it only is effective after changing to OPMODE 1.

If no parameters are programmed when HSC programming is enabled, the following default values are valid:

OPMODE

1

CONTERROR

0.1 mm

Notice

notice

The parameters may also be specified in several steps. This means that it is possible to first enable the operation mode ("OPMODE") and HSC processing ("ON") in the first command and then change the maximum contour error ("CONTERROR") in a second command.

An error message is generated if the operation mode is changed while HSC processing is enabled.