Continuous jog mode

Release Note

release_note

As of Build V2.11.2010.02, the command #JOG CONT [...] replaces the command #SET TIP [...]. For compatibility reasons, this command is still available but it is recommended not to use it in new NC programs.

#JOG CONT [ AX<axis_name> | AXNR<expr> FEED1<expr> [FEED2<expr> FEED3<expr>] ] (modal)

AX<axis_name>

Name of manual mode axis

AXNR<expr>

Logical number of manual mode axis, positive integer.

FEED1<expr>,

FEED2<expr>,

FEED3<expr>

 

Velocity stages (maximum 3) in [mm/min, m/min, inch/min, °/min]

Programing Example

prg_example

Continuous jog mode

When the axis name is specified:

G202 X1

...

#JOG CONT [AX=X FEED1=1.0 FEED2=1.5 FEED3=2.0]

...

G201 X1

...

..or when the logical axis number is specified:

G202 X1

...

#JOG CONT [AXNR=1 FEED1=1.0 FEED2=1.5 FEED3=2.0]

...

G201 X1

...