Units used in PLC Open functions (P-CHAN-00182)

P-CHAN-00182

Units used in PLC Open functions

Description

When PLCopen functions (S[MC_..], see [PROG//section PLCopen functions]) the corresponding specified units must be used in the default setting. Normally, these are value settings in so-called internal units, such as 0.1 µm or mm/s² etc.

By setting the parameter 'plcopen_std_unit', the values of PLC Open functions can be programmed in the units usually used in the NC program, such as mm, mm/s, m/min etc. Based on the configured resolution factors (*) these values are then recalculated in the internal controller.

Parameter

plcopen_std_unit

Data type

BOOLEAN

Data range

0: Specify values of PLCopen functions in the specified (internal) units (default).

1: Define values of PLCopen functions in default units.

Dimension

----

Default value

0

Remarks

* Replaced as of CNC Build V2.11.2026.09 P-CHAN-00315 replaces the parameters lin_aufloes, rund_aufloes and spind_aufloes (P-CHAN-00034in normal mode P-CHAN-00035 and P-CHAN-00036). It is recommended to use only P-CHAN-00315 as of this CNC Build.