Single-step operating mode (P-CHAN-00015)

P-CHAN-00015

Define single-step operating mode

Description

If the parameter is set to -1 and single-step mode is activated, it is only possible to stop by operator action at the end of NC blocks with axis movements.

If the parameter is set to 0 and single-step mode is activated, it is only possible to stop by operator action at the end of NC blocks with axis movements and other NC blocks with relevant control information.

If the parameter is set to 1 and single-step mode is activated, it is only possible to stop by operation action at the end of every NC block. Only comment lines are skipped.

If motion blocks are inserted by specific NC functionality (TRC, SPLINE, polynomial smoothing over, etc.) and block boundaries are altered, these new block boundaries also determine stopping in the single step mode.

Parameter

einzelschrittmodus

Data type

SGN16

Data range

-1: Single-step mode only for NC motion blocks

0: Single-step mode for NC motion blocks and relevant control blocks (default)

1: Single-step mode for all NC blocks

Dimension

----

Default value

0

Remarks