Warning message if residual motion path is too small (P-CHAN-00299)

P-CHAN-00299

Output of a warning message if residual motion path is too small at edge banding

Description

After the measurement signal is received, the CNC executive plausibility checks for the residual path at edge banding, e.g. whether the residual path is greater than the deceleration distance. By default the CNC generated error messages (P-ERR-50443in normal mode P-ERR-50498 or P-ERR-50065) if the expected conditions are not fulfilled. By setting the parameter to 1, the error message can be changed into warning messages. Program processing is then continued and the axes move to the target point of the measurement run. The faulty measurement must be treated properly by the user e.g. in the PLC.

Parameter

kasto_warning_residual_path

Data type

BOOLEAN

Data range

0/1

Dimension

----

Default value

0

Remarks

This parameter can only be used in the ‘Reject rest block’ mode (P-CHAN-00149 must therefore be set to the value 1).

Parameterisation example:

# Reject rest block

kasto_reject_rest_block       1

# Raise warning messages, when remaining residual path is too small.

kasto_warning_residual_path   1