Programmed measurement signal (P-CHAN-00257)

P-CHAN-00257

Switch over measurement logic to a programmed measurement signal at edge banding

Description

Typically, the measurement signal for the CNC is routed either via the drive bus or is set by the PLC via the HLI interface.

When the channel parameter P-CHAN-00257 is set to 1, as an alternative you can switch over to a 'programmed measurement trigger signal' that is active in the path interpolator.

The measurement trigger signal is then triggered via the NC command #MEAS [TRIGGER] within the G108/G107 range. Activation of the measurement logic in the drive and the response to the measurement signals from the drive or the PLC are then deactivated.

Parameter

kasto_prog_meas_trigger

Data type

BOOLEAN

Data range

0/1

Dimension

----

Default value

0

Remarks

It only makes sense to use this parameter if P-CHAN-00029 (kasto_multi_block) is assigned FALSE.

Parameterisation example:

kasto_prog_meas_trigger 1

Switch over measurement logic to a programmed measurement signal at edge banding
Switch over measurement logic to a programmed measurement signal at edge banding

Programing Example

prg_example

%meas

N10 V.G.RW= 20              ;Residual path after measurement signal 20mm

N20 G00 G90 X0 Y0

N30 G01 X50 F5000

N40 G108 F2500              ;Activate edge banding function

N50 G01 G90 X100 Y100 M33   ;M function 33 of type MNE_SNS

N60 #MEAS [TRIGGER]         ;Trigger measurement signal at actual position

N70 X150 Y150

N80 X200 Y200

N90 G107                    ;Deselect edge banding

M30