ID 51048

Too small P-STUP-00033 leads to delayed display of the HLI variable dist_to_geom_end_r.

Description

The NC command #DIST TO GO BEGIN flags the start of a sequence for which the axis path is to be calculated up to the end of the sequence with #DIST TO GO END.

The entire sequence must be available in order to determine the axis path up to the end of the sequence. This is not always possible if P-STUP-00033 is parameterised too small.

If the memory is too small, the axis travel path cannot be calculated up to the #DIST TO GO END flag and the display via the HLI datum dist_to_geom_end_r remains invalid until the sequence is fully available.

Response

Class

1

Warning, no reaction.

Solution

Class

1

Check and correct the parameter P-STUP-00033

Parameter

%1:

Block number [-]

Block number of the last NC block that is still within the sequence. Acts as a reference point for increasing P-STUP-00033.

Error type

-