Coordinate systems for erosion on the path

If a coordinate system is selected for erosion on the path, the identical coordinate system must be programmed in the down and escape channels.

The coordinate system must be selected in the down channel before the escape channel is activated. Activation of the escape channel implicitly indicates the start of the erosion phase [Escape channel].

The following program example consists of the programs in the sections Standard program structure - down channel and the escape channel and only lists the specific lines for the coordinate system for erosion on the path.

Notice

notice

It is not possible to change the coordinate system when erosion on the path is active.

Programing Example

prg_example

Using a coordinate system for erosion on the path

Programing Example

prg_example

Down channel

%sinking_Beispielprogramm

;---- Activate the escape channel -> implicit start of erosion on the path

N050 #CS ON [EAB] [V.P.Appr_Start_TRANS_X, V.P.Appr_Start_TRANS_Y,0, V.P.Appr_Start_ROT_X,0,0] ; define CS

N5100 #MC_MovePath SYN [ CH="CH-Escape" ID="MC-Escape" FileName="DsEscapeFile" \

@PL1=V.P.Appr_Start_ACS_X @PL2=V.P.Appr_Start_ACS_Y @PL3=V.P.Appr_Start_ACS_Z \

@PL4=V.P.Appr_Start_TRANS_X, @PL5=V.P.Appr_Start_TRANS_Y, @PL6=V.P.Appr_Start_TRANS_Z, \

@PL7=V.P.Appr_Start_ROT_X, @PL8=V.P.Appr_Start_ROT_Y, @PL9=V.P.Appr_Start_ROT_Z \

@PL10=V.P.Appr_Start_ACS_A @PL11=V.P.Appr_Start_ACS_B @PL12=V.P.Appr_Start_ACS_C @PL13=V.P.EscapeMode \

@PL14=V.P.AlphaAngle @PL15=V.P.PointY @PL16=V.P.PointZ]

N070 L patherosion.sub

Programing Example

prg_example

Escape channel

%escape

;…

N3060 #ESCAPE PATH DEF BEGIN

N3070 #CS ON [EAB] [@PL4,@PL5,@PL6,@PL7,@PL8,@PL9]

L patherosion.sub

N3100 #CS DEL ALL

N3110 #ESCAPE PATH DEF END

;…