Parameterisation
Required input parameters
Input parameters | Description |
@P1 | Reference plane (absolute) |
@P2 | Retraction plane (absolute) |
@P3 | Safety clearance in Z (relative to reference plane/machining height) |
@P4 | Pocket depth (relative to reference plane) |
@P6 | Maximum infeed in XY in reference cycle (Maximum V.G.WZ_AKT.R) |
@P11 | Number of infeeds (unsigned) Maximum infeed depth is calculated from [depth (@P4) / number of infeeds (@P11)] |
@P31 | Machining mode: 1: chip breaking 2: chip evacuation |
@P35 | Reference cycle 1: SysMillContourPocket.ecy 2: SysMillContourSpigot.ecy |
@P61 | Return clearance for chip breaking and holding distance after chip evacuation (unsigned) |
@P130 | Milling cutter radius in reference cycle |
@P50 | Identification number of the pocket or blank contour for reference cycle |
Optional input parameters
Input parameters | Description |
@P16 | Finishing allowance at edge in reference cycle Default value = 0 |
@P30 | Machining direction for reference cycles "ClimbMilling" or 0: Down milling (default) "UpCutMilling" or 1: Up milling |
@P92 | Retraction mode: 0: retract at rapid traverse (default) 1: retract at feed rate |
@P131 | Drilling depth Default value = pocket depth |
@P132 | Feed rate for drilling (values in mm/min, inch/min) Default value = active feed rate |
@P133 | Direction of spindle rotation for reference cycle 3: clockwise (default) 4: counter-clockwise |
@P51 | Identification number of an island contour for reference cycle |
@P52 | Identification number of an island contour for reference cycle |
@P53 | Identification number of an island contour for reference cycle |
@P54 | Identification number of an island contour for reference cycle |
@P55 | Identification number of an island contour for reference cycle |
@P56 | Identification number of an island contour for reference cycle |
@P57 | Identification number of an island contour for reference cycle |
@P58 | Identification number of an island contour for reference cycle |
@P59 | Identification number of an island contour for reference cycle |
@P60 | Identification number of an island contour for reference cycle |
It is recommended to use the Syntax check to verify whether the input parameters are correctly assigned.