Parameterisation
Required input parameters
Input parameters | Description |
@P1 | Reference plane (absolute) |
@P2 | Retraction plane (absolute) |
@P3 | Safety clearance in Z (relative to reference plane/machining height) |
@P4 | Depth of slot (relative to reference plane) |
@P5 | Maximum infeed in Z |
@P6 | Maximum infeed in XY plane (Maximum 2*V.G.WZ_AKT.R) |
@P43 | Opening angle of the slot in X (maximum 360°) |
@P44 | Number of slots |
@P73 | Width of slot |
@P74 | Circle radius of centre point positions |
Optional input parameters
Input parameters | Description |
@P7 | Pitch of plunge helix with helical infeed in Z Default value = 10% of tool radius |
@P8 | Radius of plunge helix with helical infeed in Z Default value = 10% of tool radius |
@P9 | Plunge angle for oscillating infeed in Z Default value = 2 degrees |
@P13 | Safety clearance on retraction in XY plane (relative to milled edge) Default value is half the slot width |
@P15 | Finishing allowance at base Default value = 0 |
@P16 | Finishing allowance at edge Default value = 0 |
@P20 | Feed rate for roughing for milling in the XY plane (specified in mm/min, inch/min) |
@P21 | Feed rate for roughing for infeed in Z (specified in mm/min, inch/min) |
@P22 | Feed rate for finishing for milling in the XY plane (specified in mm/min, inch/min) The default value is the feed rate for roughing |
@P23 | Feed rate for finishing for infeed in Z (specified in mm/min, inch/min) The default value is the feed rate for finishing for milling in the XY plane |
@P25 | Spindle speed for finishing (specified in rpm) Default is the spindle speed at cycle call |
@P30 | Machining direction "ClimbMilling" or 0: Down milling (default) "UpCutMilling" or 1: Up milling |
@P31 | Machining mode: "Roughing" or 1: Roughing "Finishing" or 2: Finishing "Roughing+Finishing" or 3: Roughing and finishing (default value) |
@P32 | Feed mode in Z 1: vertical 2: helical 3: Oscillating (default value) |
@P40 | Position of circle centre point in X (absolute) Default value is the current position |
@P41 | Position of circle centre point in Y (absolute) Default value is the current position |
@P45 | Starting angle of first slot (in degrees) Default value = 0 |
@P46 | Incremental angle (in degrees) Default value = 360°/number of slots |
@P135 | Maximum infeed in XY for edge finishing Default value is the maximum infeed in XY for roughing |
@P170 | Maximum infeed in XY for base finishing Default value is the maximum infeed in XY for roughing |
@P171 | Feed rate for plunging in previously milled areas Default value is the feed rate for roughing for the infeed in Z |
The function of the parameters acting in the XY plane is derived largely from the graphic below:
It is recommended to use the Syntax check to verify whether the input parameters are correctly assigned.
Parameters which mainly refer to the Z axis are displayed in the graphic below:
