Parameterisation

Required input parameters

Input parameters

Description

@P1

Reference plane (absolute)

@P2

Retraction plane (absolute)

@P3

Safety clearance (relative to the reference plane, unsigned)

@P4

Final drilling depth (relative to the reference plane, unsigned)

Optional input parameters

Input parameters

Description

@P17

Dwell time at final drilling depth (in seconds, default value = 0)

@P68

Centring diameter (if specified, @P4 is not considered)

@P87

Point angle of drilling tool (default value = 90)

If @P68 is active, @P87 is used to calculate the centring diameter.

If @P68 is not active, @P87 is used to calculate the dimension from the point to the lateral surface of the tool.

The calculated dimension is added to the final drilling depth.

The drill radius is read from the tool memory to calculate the new final drilling depth. The radius in the tool memory may not be 0.

@P182

Activate breakthrough detection. For more information, see below.

0: breakthrough detection inactive (default)

1: breakthrough detection active

It is recommended to use the Syntax check to verify whether the input parameters are correctly assigned.

Breakthrough detection

The breakthrough detection (@P182) function stops drilling operations after a breakthrough is detected. Movements in the form of a measuring block (G100) are therefore executed during machining. If a probe signal occurs during the process, the drilling operation is interrupted and the tool is retracted to the retraction plane in rapid traverse after the specified dwell time.

Attention

attention

If breakthrough detection is active, measuring mode 1 is activated in the cycle.