PROFIDRIVE

Drive parameters

In order to use the measurement function, the rapid digital input I0.0, or I0.X for a double-axis module, must be programmed.

  1. The value 80 must then be assigned to the drive parameter P0660.
  2. Connect the measuring probe to the digital input I0.0 or I0.X.

Axis parameters

For PROFIBUS drives, the following entries must be assigned in the axis parameter lists:

P-AXIS-00518

(old P-AXIS-00113)

Latch at positive or negative probing signal edge:

     kenngr.measure.edge      POS / NEG