Parameters

In addition to the parameters described, the SysCalibConfigLaser.nc calibration file is executed during the cycle. Its function is to parameterise the laser measuring station and must be filled with the result values of the calibration cycle.

Input parameters

Description

@P33

Permissible tolerance of the measuring points to determine tool breakage.

If this value is exceed, it is evaluated as a tool breakage.

(default = 0.5)

@P37

Permissible tolerance of the measuring points to determine tool wear.

(default = 0.1)

It the tolerance is too small, it may result in unnecessary machine stops.

@P67

Radius offset (lateral offset when probing)

Only positive values are permissible.

Set the offset according to the tool measurement.

(default = 0)

@P70

0 (default) = warning when tool is worn, 1 = stop when tool is worn

@P71

0 (default) = warning when tool breaks, 1 = stop when tool breaks

It is recommended using the Syntax check to verify whether the input parameters have been correctly assigned.