ID 70172

Logical interpolator axis cannot be connect with the physical position-controller axis.

Description

Multiple instancing of an axis allows the same drive to be commanded from different NC channels (one after the other) without axis exchange. Parameter P-AXIS-00101 can be used to assign a physical position controller axis to a logical interpolator axis. However, the axis in the position controller could not be found since the given logical axis number in this parameter does not exist.

Response

Class

7

Open-loop controlled stop of concerned axis

Solution

Class

6

Correct parameter P-AXIS-00101

Parameter

%1:

Logical axis number [-]

Logical axis number of interpolator axis see P-AXIS-00016

%2:

Expected value [-]

Logical axis number of physical axis in position controller that was not found see P-AXIS-00016

Error type

11, Error message from position controller.