ID 21905

Contour path with given angles and end position not possible.

Description

Contour path of 2 blocks is programmed.

The programmed end position of contour path is unfit with the given angles.

 

Example with error:

N250 G18 G01 Z10 X5  (SP - Starting point)
N260 #ANG=30
N270 #ANG=120 G01 Z-10 X10  (EP1 - End position)

 

Corrected example:

N250 G18 G01 Z10 X5  (SP - Starting point)
N260 #ANG=30
N270 #ANG=120 G01 Z5 X20  (EP2)

 

In the following figure the permitted area of the end position with the given angles is shown:

 

Response

Class

2

Abort NC program processing.

Solution

Class

3

Check and modify the contour path in NC program.

Correct the end position of contour path or

Correct the angle of contour path

Parameter

%1:

Initial value [0.1 µm or 0,0001°]

Startpoint of contour path.

%2:

Current value [0.1 µm or 0,0001°]

Programmed angle of first block

%3:

Current value [0.1 µm or 0,0001°]

Programmed angle of second block.

%4:

End value [0.1 µm or 0,0001°]

Incorrect end position of contour path

Error type

1, Error message from NC program.