ID 13112
Retraction mode is unknown. | |||
Description | An invalid value was found in the optional parameter that defines the retraction process after the machining depth is reached. The following modes are available: 0 - Retract in rapid traverse in Z direction G00 (default), 1 - Retract at feed rate G01, not available in all cycles -> 2 - Stop spindle at defined position M19 S.POS Retract at feed rate G01 in X and Z directions Retract at rapid traverse in Z direction G00 3 - Stop spindle M5, retract at rapid traverse in Z direction G00 | ||
Response | Class | - | Error: Transition to error state. Complete reset of the NC channel necessary. |
Solution | Class | - | Check parameter setting and correct the input parameters for retraction motion. |
Error type | 1, Error message from the NC program | ||
|