Parameterising corner deceleration (#CORNER PARAM)
Release Note
As of Build V2.11.2010.02 the command #CORNER PARAM [...] replaces the command #SET CORNER PARAM [...]. For compatibility reasons, this command is still available but it recommended not to use it in new NC programs.
Syntax: |
#CORNER PARAM [ DIST=.. UNIT=<ident> FEED=.. ] |
DIST=.. | Corner distance in [mm, inch] |
UNIT=<ident> | Corner feed unit FEED=... Permitted identifiers: FWORD Unit according to current F word PERCENT Unit in [%] |
FEED=.. | Corner feed rate, [according to UNIT<ident>] |
The point in space after which the path feedrate is to be reduced linearly along the path can be calculated by specifying a corner distance. The corner distance to be programmed refers here to the corrected path, not to the originally programmed target points.
Notice
Corner deceleration is only effective in combination with the linear slope P-CHAN-00071.
