Settings for edge banding
Edge bending is described in more detail in [PROG].
Additional information
- Residual path (P-CHAN-00030)
- Block global edge banding (P-CHAN-00029)
- Reject rest block (P-CHAN-00149)
- Modal active measurement (P-CHAN-00153)
- Suppress motion path check (P-CHAN-00227)
- Programmed measurement signal (P-CHAN-00257)
- Residual path related to contour (P-CHAN-00258)
- Warning on non-detection of probing signal (P-CHAN-00298)
- Warning message if residual motion path is too small (P-CHAN-00299)
- Outputting an MNE_SNS technology function at measuring event (P-CHAN-00435)