Probing input for edge banding (P-AXIS-00539)
P-AXIS-00539 | Probing input for edge banding | |
Description | By default the same probing input used for probing is also used for edge banding. This parameter configures an alternative probing input for edge banding. When this parameter has no value assigned or is assigned the value 0, the default behaviour applies. The admissible range of the parameter depends on the drive type. This parameter replaces the setting antr.edge_bending_input_nbr (P-AXIS-00353). | |
Parameter | kenngr.measure.input_edge_banding | |
Data type | UNS08 | |
Data range | 0 .. MAX(UNS08) | |
Axis types | T, R, S | |
Dimension | T: ---- | R,S: ---- |
Default value | 0 * | |
Drive types | SERCOS, Profidrive | |
Remarks | This parameter is available as of Build V3.1.ff. If the parameter is assigned a value other than unequal to zero for drive types other than SERCOS and Profidrive, an error message (ID 110614) is output and the parameter is set to 0. If the parameter is assigned an invalid value, an error message (ID 110615) is output and the parameter is set to 0. * If the parameter P-AXIS-00539 is not specified, the setting in P-AXIS-00353 is used for reasons of backward compatibility. | |