Deselecting zero offsets (P-ZERO-00001)

P-ZERO-00001

Deselecting zero offsets

Description

This parameter allows the use of the G53 data record to define an additional offset data record.

Parameter

g53_verfuegbar

Data type

BOOLEAN

Data range

0/1

Dimension

----

Default value

0

Remarks

This datum controls the significance of zero offsets with the zero offset group index '0' which are selected by 'G53' or 'G159 = 0' in the NC program. If g53_verfuegbar is not assigned or is assigned with zero, all zero offsets are removed from the calculation (deselection) of the motion paths when 'G53' or 'G159 = 0' is programmed in the NC program.**

On the other hand, when g53_verfuegbar = TRUE, the zero data record can also be used as a full zero offset with offset values not equal to zero. See also [PROG].

** G53 is only active automatically in the basic state when P-ZERO-00002 is not assigned or is assigned with zero.